Page 1 of 1

Print quality

Posted: Tue Jun 25, 2019 10:27 pm
by moldrodger
on my Promega when i print a calibration cube 2 side are smooth and 2 side are slightly rough. Can anyone point me in the right direction to fix this issue.

Re: Print quality

Posted: Wed Jun 26, 2019 4:15 pm
by TheBum
Check to make sure both X-Y belts are reasonably tight and of equal tightness.

Re: Print quality

Posted: Sat Jun 29, 2019 10:26 pm
by moldrodger
i checked my belts i think i just needed to oil my bearing for the belt rollers. after i oiled the bearing my print quality improved.