Print quality

Post Reply
moldrodger
Posts: 2
Joined: Tue Jun 25, 2019 10:22 pm

Print quality

Post by moldrodger » Tue Jun 25, 2019 10:27 pm

on my Promega when i print a calibration cube 2 side are smooth and 2 side are slightly rough. Can anyone point me in the right direction to fix this issue.

TheBum
Posts: 48
Joined: Tue Sep 11, 2018 4:41 pm

Re: Print quality

Post by TheBum » Wed Jun 26, 2019 4:15 pm

Check to make sure both X-Y belts are reasonably tight and of equal tightness.

moldrodger
Posts: 2
Joined: Tue Jun 25, 2019 10:22 pm

Re: Print quality

Post by moldrodger » Sat Jun 29, 2019 10:26 pm

i checked my belts i think i just needed to oil my bearing for the belt rollers. after i oiled the bearing my print quality improved.

Post Reply